YUANNENGJI Use screws or glue to fix the lamp body directly in the required position, connect the power cord and signal line according to the installation diagram, and make it waterproof. Note that the power supply must match the power supply of the lamp. The rated voltage of the lamp is DC5V/DC12V/DC 24V. Remember not to connect directly to 220V, otherwise the LED point light source will burn out.
When plugging and unplugging the SD card, please disconnect the power supply of the controller, otherwise the SD card may burn out. The positive and negative poles of the power output cannot be reversed or short-circuited with the positive and negative poles of the LED light source, otherwise the lamp IC will burn out and the signal cannot be transmitted. Калі вы хочаце ўсталяваць кропкавы крыніца святла агароджы лямпы на сцяне, трэба прасвідраваць дзірку ў сцяне, усталюйце распорный шруба, а затым усталяваць агароджу кропкавай крыніцы святла, і зафіксуйце лямпу агароджы некалькімі саморезы.
Адлегласць паміж кожнай лямпай агароджы неабходна арганізаваць у адпаведнасці з патрабаваннямі заказчыка; наогул кажучы, адлегласць паміж 1cm і 3cm. Злучыце шнур сілкавання і сігнальны шнур агароджы кропкавай крыніцы святла адзін з адным. Наогул кажучы, сеткавы шнур - двухжыльны, а сігнальны - чатырохжыльны або пяціжыльны.
Для ўстаноўкі святлодыёднага крыніцы святла профільны фіксатар, зафіксуйце два мантажных кранштэйна на сцяне ў адпаведнасці з інтэрвалам, lock the lamp on the aluminum profile with screws, and then lock the locked lamp profile on the mounting bracket. Lock the two mounting brackets on the mounting wall according to the spacing, buckle the lamp on the aluminum profile with a connecting buckle, and then lock the fixed lamp profile on the mounting bracket. For the profile lock wall installation, first lock the lamp on the aluminum profile with screws, then lock the locked lamp profile on the mounting wall, clamp the lamp on the aluminum profile with a connecting buckle, and then lock the fixed lamp profile on the mounting wall, fix the lamp with a lampshade on the aluminum profile with screws, and then lock the fixed lamp profile on the mounting wall.
For installation on the road trough track, first fix the bottom shell, then insert the point light source into the aluminum groove with holes punched in advance, and then buckle it directly on the bottom shell. It is beautiful and elegant, without any lines, and has a wide range of uses. It can also be called an LED invisible light. The light spot cannot be seen during the day, but it is bright at night. It can be installed on the roof to resist typhoons.
Installation with buckle thread: insert the buckle thread into the steel wire, and then insert the point light source into the buckle thread; suitable for glass curtain walls or hoisting. Installation with whole plate punching: punch holes in iron plates, aluminum plates, and stainless steel plates, then pass the point light source through the back, connect the wires and install. Гэты спосаб мантажу таксама выкарыстоўваецца часцей.